CAUSE: | You specified a migration device for the current design's target device. However, the output drivers between two GNDIO pins sink a total current exceeding the specified maximum current. The output drivers between two GNDIO pins must sink a total current that is equal to or less than the specified maximum current. |
ACTION: | Make sure the output drivers between two GNDIO pins do not sink a total current exceeding maximum total current that the migration device can sink between two GNDIO pins. |
See also:
Assigning Pins
Deleting Assignments in the Assignment Organizer
Overview: Making Assignments
Overview: Working with Assignments in the Floorplan Editor
Specifying Devices for Device Migration
- PLDWorld - |
|
Created by chm2web html help conversion utility. |