Quartus

Device family <name> does not support SignalTap II incremental routing


CAUSE: You attempted to perform SignalTap II incremental routing by either adding a SignalTap II post-fitting node and compiling the design, or reserving a greater number of trigger and/or data nodes than what is assigned, and compiling the design. However, the specified device family does not support the SignalTap II incremental routing feature. This feature is supported only for APEX 20K, APEX II, ARM-based Excalibur, Cyclone, Stratix, and Stratix GX devices.
ACTION: Remove the incremental routing settings from the SignalTap II File (.stp), or specify an STP File that does not use the incremental routing feature.

See also:

Overview: Using the SignalTap II Logic Analyzer
Performing SignalTap II Incremental Routing

- PLDWorld -

 

Created by chm2web html help conversion utility.