Quartus

CONF_DONE pin failed to go high


CAUSE:

The CONF_DONE pin, located in the device(s) you attempted to configure by clicking Start in the Programmer window, did not go high at the end of configuration as it should have done. For this reason, configuration was unsuccessful. This problem may be caused by:

  • Communications cables not securely connected

  • Incorrect device selected

  • No power to target system

ACTION: Make sure all communication cables are securely connected, select a different device, or check the power on the target system.

See also:

Image of Programmer
"Installing Programming Hardware" in either the Quartus II Installation & Licensing for PCs manual or the Quartus II Installation & Licensing for UNIX and Linux Workstations manual

- PLDWorld -

 

Created by chm2web html help conversion utility.