| CAUSE 1: | You tried to configure a device with the ByteBlasterMV, ByteBlaster II, or MasterBlaster communications cable, but the Programmer did not successfully load the data into the device. This problem can be caused by:
|
| ACTION: | Make sure all cables are securely connected, select a different device, or check the power on the target system. |
| CAUSE 2: | You tried to configure a device with the ByteBlasterMV, ByteBlaster II, or MasterBlaster communications cable, and you directed the device to use a user-supplied clock on the CLKUSR pin for initialization, but you did not supply a start-up clock for initialization of the CLKUSR pin. As a result, the data did not load successfully into the device. |
| ACTION: | Make sure you have specified a start-up clock for initialization of the CLKUSR pin, or specify that the device not use a user-supplied clock on the CLKUSR pin for initialization. |
See also:
Adding or Replacing a Device in a JTAG Chain
Image of Programmer
Programming a Single Device or Multiple Devices in JTAG or Passive Serial Chains with the MasterBlaster, ByteBlasterMV, or ByteBlaster II Download Cable
Specifying General Device Options
"Installing Programming Hardware" in the Quartus II Installation & Licensing for PCs manual
"Installing Programming Hardware" in the Quartus II Installation & Licensing for UNIX and Linux Workstations manual
|
- PLDWorld - |
|
|
| Created by chm2web html help conversion utility. |