Quartus

Device did not accept configuration data (after <number> bits sent)

CAUSE:

You tried to configure a device with the MasterBlaster, ByteBlaster II, or ByteBlasterMV communications cable by clicking Start in the Programmer window, but the device did not accept the data from the programmer. This problem can be caused by:

  • Incorrect device selected

  • User startup clock selected but no running clock connected to CLK_USR pin

  • Communications cables not securely connected

  • No power to target system
ACTION: Make sure all cables are securely connected, select a different device, check the power on the target system.Make sure you have connected a start-up clock for initialization of the CLKUSR pin, or turn off the Enable user-supplied start-up clock option.

- PLDWorld -

 
Created by chm2web html help conversion utility.