Quartus

Can't perform HardCopy performance estimation on design before timing analysis -- run timing analysis on design

CAUSE: You tried to perform a HardCopy performance estimation on the current design. However, you did not first run a timing analysis on the design. To estimate HardCopy fMAX for a clock signal in a design, the Performance Estimator requires the fMAX value that the Timing Analyzer reports for the clock signal. Therefore, the Performance Estimator cannot estimate the HardCopy fMAX for any clock signals in the design until you run a timing analysis.
ACTION: Run a timing analysis on the design before performing a performance estimation.

See also:

Running a Timing Analysis

- PLDWorld -

 
Created by chm2web html help conversion utility.