Quartus

Can't scan device chain


CAUSE: You set up a device chain in the Programmer window, selected a programming hardware setup from the Hardware Settings tab of the Hardware Setup dialog box, and clicked Auto Detect in the Programmer window. However, the programming hardware you selected is either not connected to the port you specified in the Hardware Setup dialog box, the port is already in use, or the device chain could not be scanned.
ACTION: Click OK to close the message dialog box. Make sure that the programming hardware you selected is connected and that nothing else is using the selected port, and that power to the board is on.

- PLDWorld -

 

Created by chm2web html help conversion utility.