CAUSE: | You either ran the SignalTap II Logic Analyzer, saved a SignalTap II File (.stp), or saved acquisition data to the data log. However, either the Data Nodes Allocated box or the Trigger Nodes Allocated box is set to 0, and you did not turn on nodes in the Data or Trigger columns. As a result, the SignalTap II Logic Analyzer is configured with zero input width on the specified input type. |
ACTION: | Click OK to close the message dialog box. If this is not what you intended, assign nodes to either data or trigger input. |
See also:
Overview: Using the SignalTap II Logic Analyzer
Programming a Device in the SignalTap II Logic Analyer
Running the SignalTap II Logic Analyzer
Saving & Viewing Acquired Data in the Data Log
- PLDWorld - |
|
Created by chm2web html help conversion utility. |