CAUSE: | In the current design, the Design Assistant found the specified number of nodes where you connected a clock signal source (for example, an input clock pin) so it drives both input clock ports and ports that are not input clock ports. However, you should connect a clock signal source so it drives only input clock ports of registers. The submessage(s) of this message list the node(s) that the Design Assistant found. |
ACTION: | Remove the connections between the clock signal sources and any ports they drive that are not input clock ports of registers. |
See also:
Analyzing Designs with the Design Assistant
Clock Signal Source Should Drive Only Input Clock Ports
- PLDWorld - |
|
Created by chm2web html help conversion utility. |