| CAUSE: | In the current design, the Design Assistant found the specified number of nodes where you connected an reset signal source (for example, an input reset pin) so it drives both input reset ports and ports that are not input reset ports. However, you should connect a reset signal source so it drives only input reset ports. The submessage(s) of this message list the node(s) that the Design Assistant found. |
| ACTION: | Remove the connections between the reset signal sources and any ports they drive that are not input reset ports. |
See also:
Analyzing Designs with the Design Assistant
Reset Signal Source Should Drive Only Input Reset Ports
|
- PLDWorld - |
|
|
| Created by chm2web html help conversion utility. |