1. To start this lab, invoke Precision Synthesis or issue the
pull-down command from the menu,
File > New Project. Do not save the old project.
Set the working directory to "Lab3".
Using the Design Bar, set up the design for the Stratix EP1S25F1020C-5. Do not set a design frequency. We will be using the constraint editor to set constraints.
File > New Project. Do not save the old project.
Set the working directory to "Lab3".
Using the Design Bar, set up the design for the Stratix EP1S25F1020C-5. Do not set a design frequency. We will be using the constraint editor to set constraints.